User's Guide

5-36
Upgrades and Options
Figure 5-15. Removing Front Plastic Cover
POWER
STATUS
DISK
POWER
RESET
B
A
C
Removing front plastic cover
from media and diskette drive
bays
A Thumbscrew that secures
the front plastic cover to the
front of the chassis
B Four snap-in tabs that
secure the front plastic cover
to the top and middle of the
chassis
C Two frame hinge tabs
7. From the bay where you want to install a drive,
remove the two screws securing the blank panel tray
to the chassis (Figure 5-16).
8. Grasp the blank panel tray and slide it out of the
bay.
9. Remove the two screws securing each side rail to the
blank panel tray (Figure 5-17).
10. Save the blank panel tray and screws to reuse if you
remove a drive from a bay later and do not reinstall
one.