User's Guide

TIP:
• If the update has been finished, the result is shown in LatestApplyResult property of `show
/cmps/<Component Name>/map/expup/mods/<Module Name>` command.
LatestApplyResult=4/1/2011 12:00:00
Applying the update package has been completed successfully.
(NEC ExpressUpdate Agent: 2.0 -> 3.0)
4.2.1.2 For the specified component and module
'load' command at the below target enables you to update the module <Module Name> of the component
<Component Name> using the specified update package.
• /cmps/<Component Name>/map/expup/mods/<Module Name>
Specific option of this command is as follow.
Table 4-13 Specific options of '/cmps/<Component Name>/map/expup/mods/<Module Name>'
Option Description
-source Specifies the update package.
-f | -force Enables NEC ExpressUpdate to update the module using an update package which is
not latest.
-reboot Enables NEC ExpressUpdate to reboot the system if the update requires it.
CHECK：
• In the case of the user authority is Operator, "Install Update Packages" of the user level
must be enabled.
TIP:
• UFiT of the update package that is referred by –source option is shown in the result of
`show /cmps/<Component Name>/map/expup/mods/<Module Name>/uppkgs` command.
Example
`load /cmps/ <Component Name>/map/expup/mods/ <Module Name>` command enables you to update the
module <Module Name> of the component <Component Name> using the specified update package.
-> load -force -source "2.0" /cmps/Server01/map/expup/mods/"NEC ExpressUpdate Agent"
COMMAND COMPLETED
Updating was started. Run the show command to the each module element and you can confirm this
command's progress from ExpUpStatus property. Run the show command to the each module element and
you can confirm this command's result from LatestApplyResult property.
/cmps/ Server01/map/expup/mods/"NEC ExpressUpdate Agent"
31