Operation Manual

8-20
Advanced
IP Address
An IP address can be automatically assigned to this projector
by your DHCP server. If your network does not automatically
assign IP address, ask your network administrator for an ad-
dress, and then register it manually.
Automatic .... Automatically assigns an IP address to the pro-
jector from a DHCP server.
Manual ........ Provides a space for you to register the IP ad-
dress or subnet mask number obtained from your
network administrator.
IP Address ... Set your IP address. Press 왔 to display the soft-
ware keyboard and type in 12 numeric charac-
ters.
Subnet Mask Set your subnet mask number. Press 왔 to dis-
play the software keyboard and type in 12 nu-
meric characters.
Gateway ...... Set the default gateway of the network connected
to the projector. Press 왔 to display the software
keyboard and type in 12 numeric characters.
Checking this box will make the set default route
valid.
When data is sent from the LAN card, the trans-
fer location will be searched according to the pre-
viously set routing information; however, when
the transfer location has not been found as a re-
sult of the search, the data will be sent to the
device that holds the IP address set here. The IP
address that is set here must be one that can be
identified by a search of the routing information.
DNS Configuration
.................... Type in the IP address of the DNS server on the
network connected to the projector.
12 numeric characters are used.
Domain Name
.................... Type in domain name of the network connected
to the projector. Up to 60 alphanumeric charac-
ters can be used.
Network Type (required for wireless only)
Mode:
Select communication method when using wireless LAN.
Infrastructure
.................... Select this option when communicating with one
or more equipment connected to the wireless or
wired LAN network via an access point.
802.11 Ad Hoc
.................... Select this option when using the wireless LAN
to communicate with a computer in a one-to-one
correspondence. This is a method that meets the
IEEE802.11 wireless standard.
Ad Hoc ........Select this option when using the wireless LAN
to communicate with a computer in a one-to-one
correspondence.
Easy Connection
.................... This allows you to easily set up wireless LAN
connection. See the Software Utility Installation
section for more information.
See chapter 6 “Using the Projector in a Network”.
SSID (Network name):
Enter an identifier (SSID) for wireless LAN. Communication
can be done only with equipment whose SSID matches SSID
for your wireless LAN. Up to 32 alphanumeric characters can
be used (Case sensitive).
NOTE: To disable SSID, select a space (null) or "ANY"(All caps).
Channel:
Set this option when selecting [802.11 Ad Hoc] or [Ad Hoc] in
[Mode].
Select a channel number from the pull-down list. The channel
must match for all wireless devices communicating on your
wireless LAN.
NOTE: Channels in the pull-down list are different depending on which country you
live in.
TX rate:
Select a wireless transmission speed. Normally leave it as Au-
tomatic.
Tr y another transmission speed when the connection fails.
8. Using On-Screen Menu