NAR01(Mobile Router) Instruction Manual
Contents Contents ......................................................................................... 2 Important Product Information ....................................................... 3 Safety Instructions ......................................................................... 4 Notice ............................................................................................. 8 1. Package Contents ................................................................. 11 2.
Important Product Information Important safety information regarding radio frequency (RF) exposure and use when worn The product “NAR01(Mobile Router)”is declared to conform with the essential requirements of European Union Directive 2014/53/EC RE Directive . This wireless portable device complies with the EU requirements for exposure to radio waves. Your wireless portable device is a radio transceiver and receiver.
Safety Instructions Please read these Safety Instructions carefully before using this product. These Safety Instructions show items that must be followed to prevent danger to any person and damage to property. Alert symbols below are important to fully understand these Safety Instructions. Alert symbols in this instruction manual Warning : Indicates a hazardous situation which could result in death or serious injury.
Warning ●Do not throw the product into fire. Ignition, explosion, overheating or leakage of the battery may result. ●Do not pierce the product with a nail, hit it with a hammer or step on it. Ignition, explosion, overheating or leakage of the battery may result. ●If the battery fluid gets into your eyes, immediately flush with clean water and consult a doctor. Do not rub the eyes. Otherwise, blindness may result.
●Do not use or charge a wet product. Ignition, explosion, overheating or leakage of the battery may result. ●If the liquid inside the battery leaks out, keep the liquid away from your skin such as face or hands. Otherwise, blindness or injury to your skin may result. If the liquid gets into your eyes or mouth, or attaches to your skin or clothing, flush with clean water immediately. If the liquid gets into your eyes or mouth, immediately flush with water and then consult a doctor.
Warning Other warnings ●Turn off this product in any place where use of a wireless device is prohibited, for example in an airplane or hospital. Otherwise, it may influence electronics and medical devices, and cause an incident. ●Do not place or use this product near high-precision electronics or devices which handle weak signals, for example pacemakers. Otherwise, electronics such as pacemakers may malfunction.
Notice Indicates a situation which could result in this product performing poorly or malfunctioning. What you must not do ●Do not drop or hit this product. Otherwise, it may malfunction. ●Do not leave this product in a cold place such as an ice warehouse. Otherwise, this product may operate abnormally. ●Disconnect all cords before moving this product. Otherwise, it may malfunction. ●This product may operate abnormally if the connecting cords are disconnected when it is on, or if the connection is unstable.
Other warnings ●If you turn off or disconnect this product during data communication, communication may fail or data may be damaged. If your data are important, check them against the original. Notes on wireless LAN ●The standard values of wireless LAN are the maximum theoretical values when communication is carried out with other products with the same configuration as this product. The standard values may not indicate the actual data transfer rate.
Security notes on wireless LAN products Wireless LAN has the advantage of a LAN connection without the use of LAN cables if the device is placed within the reach of radio waves. You can send and receive information between devices that use radio waves such as a computer and the wireless LAN access point (base unit).
1. Package Contents This product package contains the following items.
2. Part Names and Functions TOP Side (2)Select button (1)Power/set button (3)Select button (5)nanoIC Slot (4)USB slot Card Indicators Name Display (1) Power /set button ● (2) Select button ▲ (3) Select button ▼ Description Hold down the button to turn on/off. Short press the button to enter. Slide the menu upward.
3. Using nanoSIM Card A nanoSIM is an IC Card that stores personal information such as your phone number. Without the nanoSIM installed in this terminal, you cannot use data communication. For details on handling the nanoSIM, refer to the nanoSIM manual. When inseting and removing the nanoSIM, hold this terminal with both hands. With the IC chip side up, insert a nanoSIM to the nanoSIM slot. Push nanoSIM & Slide the nanoSIM to remove.
4. Charging the Battery Pack Charging the Battery Pack (1) Connect to The USB port of this product and PC with an attached USB TypeC cable.
5. Network Setup 3G/LTE 2G Laptop computer NAR01(Mobile Router) Wireless LAN Smart Phone Tablet Registering the Access Point Setting (1) In the top menu, click ”Basic settings” (2) In the submenu, click “Network settings(LTE/3G)” (3) Confirm “International roaming” settings area, and click “Use” (4) Confirm pop-up message, and click “OK” (5) To register International roaming setting, click “Set” (6) Click “Edit” (7) On the setting screen, set the required items.
6. Web Setting (1) Start the PC and others. (2) Start a WWW browser, enter "http://192.168.1.1/" and open the page for Web configurations. Click “詳細”. Click “web ページへ移動”.
(2) Enter the password and click “ログイン”.
(3) The "Administrator password changing" screen appears. Change the administrator's password as you like, and write it down in the "Administrator's password" box below and click "変更″. If you do not want to change the administrator password, click “スキップ”. Do not forget to write down your administrator's password. The password is essential to the configuration of this product. You need to enter the password to open the configuration screen.
(5) Select the menu you want to modify, and proceed.
7. Products Specifications Item WAN Antenna LTE_Band5 LTE_Band17 WCDMA_Band2 WCDMA_Band5 Antenna IEEE802.11b IEEE802.11g Wireless LAN IEEE802.11n IEEE802.11ax Bluetooth(*1) USB port BDR/EDR/LE Physical interface Port Type Operating conditions Dimensions Power consumption Weight Condition Antenna built in Frequency UL:824-849MHz,DL:869-894MHz Frequency UL:704-716MHz,DL:734-746MHz Frequency UL:1850-1910MHz,DL:1930-1990MHz Frequency UL:824-849MHz,DL:869-894MHz Antenna built in Frequency 2.
RF power listing (Conducted Power Table) Band Target Power (dBm) Ⅱ Ⅴ 5 17 22.0 21.5 24.3 24.3 Technology/Band Mode Target Power (dBm) WLAN 2.4GHz 802.11b 802.11g 802.11n HT20 802.11n HT40 802.11ax HE20 802.11ax HE40 14.0 13.0 13.0 13.0 10.0 10.
Notice (1) All rights reserved. No part of this manual may be copied or reproduced without prior permission. (2) Contents of this manual may change without notice. (3) We take every possible precaution to ensure the accuracy of this manual, but if anything is unclear or erroneous in the content, please contact us. (http://www.necat.co.
Europe – EU Declaration of Conformity This device complies with the essential requirements of the RE Directive 2014/53/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the RE Directive 2014/53/EC: - EN 300 328 V2.2.2 (2019-07) - EN 301 489-1 V2.2.3 (2019-11) - EN 301 489-17 V3.1.1 (2017-02) - Draft EN 301 489-52 V1.1.0 (2016-11) - ETSI EN 301 908-1 V13.1.1 (2019-11) - EN 301 908-2 V11.1.2 - EN 301 908-13 V13.1.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Important safety information regarding radio frequency (RF) exposure and use when worn The product “NAR01(Mobile Router)”is declared to conform with the essential requirements of the Federal Communications Commission of the U.S. Government. This wireless portable device complies with the FCC requirements for exposure to radio waves. Your wireless portable device is a radio transceiver and receiver.
Radiation Exposure Statement The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. FCC ID Location FCC ID is printed on the back of the device.