Operation Manual

2. Projecting an Image (Basic Operation)

❿ After Use

Preparation:Makesurethattheprojectoristurnedoff.

1. Unplugthepowercord.

2. Disconnect any other cables.

• RemovetheUSBmemoryifitisinsertedintotheprojector.

3. Retractadjustabletiltfootifextended.

(M403W/M363W/M323W/M403X/M363X/M323X/M283X/M403H/M323Honly)

4.Slidethelenscovertothelefttocoverthelens.

5. Puttheprojectorandaccessoriesinthesuppliedsoftcase.

Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from

damage.

Inserttheprojectorwiththelens

facing upward

NOTE:Whenplacingtheprojectorinthesoftcase,retractthetiltfootandtherearfeet.Failuretodosomaycasedamagetothe

projector.

(M353WS/M303WS/M333XSonly)

4. Reattach the lens cap

① Put the lens cap on the top of the lens.

② Push to cover the lens completely.

CAUTION:

Usecautionwhenputtingtheprojectorinthesoftcaseimmediatelyaftertheprojectorhasbeenoperating.The

projectorcabinetishot.