Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Status, Error, and Service Messages
109
HP-GL Error Codes and PCL Error Codes
The following tables list error codes that could appear on the printer message
window when running the HP-GL, PCL or HPXL emulation.
HP-GL PCL
Error
Code
Description Error
Code
Description
0 Not enough memory for job. 0 Not enough memory for job.
1 Too many transformations. 1 State lost.
2 Math error. 2 Math error.
3 Job aborted. 3 Job aborted.
4 Instruction not recognized. 4 Out of memory for macros.
5 Wrong number of parame-
ters.
5 Disk full. Cannot store fonts.
6 Out of range parameter, or
illegal character.
6–13 Internal error 1–8.
7 Not used.
8 Unknown character set.
9 Position overflow.
10 Buffer overflow.
11 Not used.
HPXL
Error
Code
Description
0 Not enough memory for job.
1 Math error.
2–7 Internal error 1–6