Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Lower Feeder Unit (LFU)134
1
Remove the fuser oil bottle.
Attention
Hold a sheet of paper under
the oil bottle as you remove
it, so no oil drips into the
printer.
2
Turn the nozzle on the opening on the bottom
clockwise to close it. Place the oil bottle (nozzle
up) in an oil-proof container such as a plastic bag,
until you’re ready to reinstall it.
3
Use the fuser oil remover syringe that came with
your printer or an eye-dropper to remove any
excess oil from the printer.
5"
Dispose of the oil in accordance with local safety laws and
regulations.
4
Remove the LFU from the shipping carton, and place it on a table or flat
surface near the printer.
5
Remove any tape and packing material from the LFU.
5"
We
strongly
suggest that you save the packaging materials in
case you ever need to move or ship the printer.
6
Position the LFU cable
connector away from the
rear of the LFU.
Nozzle