Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
SC-210 Color Convenience Copier
151
11
Reconnect the power cord and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is consid-
ered to be the main disconnect device.”
When you print a startup page, verify that the hard disk is listed.
SC-210 Color Convenience Copier
You can expand your magicolor 6110’s functionality by connecting an SC-210
digital color convenience copier option to the standard parallel port on the
printer. The SC-210 supports up to legal-size paper input. There are two
versions available—with or without the 30-sheet Automatic Document Feeder
(ADF).
Check the documentation included with your SC-210 for instructions on
setup, configuration, and operation.
What
'
s in the Kit?
The SC-210 kit includes the following:
„
SC-210 color convenience copier
„
Power cable, 220 V
„
Power cable, 110 V
„
Software CD-ROM
„
Parallel interface cables (2)
„
Documentation
„
User warranty and registration card
Security Key
A security key is available to password-protect the Operator Control
and the Administration menus. When the security key is installed,
the Installation menu appears in the printer’s configuration menu.
What's in the Kit?
„
A security key (9-pin connector labeled “Security”)