Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Security Key152
Setting Configuration Menu Passwords
1
Insert the security key into the “Key” port on the interface panel.
Attention
Even though both the security key and serial interface have a DB-9
interface, the connectors are keyed, and they can’t be interchanged.
Make sure that you install the security key only in the port marked
“Key.”
5"
The illustration shows the printer without the duplex unit. However,
the instructions are the same for all models.
2
Press the Online key to take the printer off line.
3
Press the Menu key.
4
Access the Installation/Operator Passwrd or Administration/Admin
Password menu.
You can use the Installation menu to password-protect just the Operator
Control menu, just the Administration menu, or both.