Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Cleaning the Printer62
5
Remove the OPC belt cartridge.
6
Clean the corona wire using the built-in wire cleaner attached to the
corona case.
While pinching the two tabs of the wire cleaner together, slide the wire
cleaner to both ends of the corona case.
Attention
Failure to return the wire cleaner to its home position (marked by an
arrow on the corona case), may degrade print quality.
7
Reinstall the OPC
belt cartridge.
Corona case
Wire cleaner