Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Cleaning the Printer64
This will allow enough
access room to clean
the lens without the
need of parts
removal.
5
Using a dry cotton
cloth, wipe the lens.
6
Close the laser lens
cover by rotating it
toward the front of the
printer.
The two tabs should
snap back into place.
7
Reinstall the four
toner cartridges.
8
Close the printer’s
front cover.
Cleaning the Exterior of the Printer
WARNING!
Turn off the printer, unplug the power cord, and disconnect all interface
cables before cleaning. Do not spill water or detergent into the printer;
otherwise the printer will be damaged and an electric shock may occur.
ACHTUNG! Ziehen Sie den Netzstecker aus der Steckdose bevor Sie
den Drucker reinigen. Verschütten Sie kein Wasser oder andere
Flüssigkeiten auf dem Drucker, da das Gerät sonst beschädigt wird
oder die Gefahr eines elektrischen Schlages besteht.
To protect your printer and maintain its appearance, clean the exterior regu-
larly. Use the following guidelines:
„
Use only a dry or slightly damp, lint-free, soft cloth moistened only with
water or mild detergent.
„
Never use cleaning solutions that contain solvents, such as alcohol and
benzene. Solvents may damage the printer’s finish.
„
Always test any cleaning solution on a small area of your printer to check
the solution's performance.
Tabs