Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Solving Problems with Printing Quality90
Back-
ground is
foggy.
The toner cartridge is
defective.
Remove the toner cartridge and check for
damage. If necessary, replace it.
The OPC belt cartridge
is damaged.
Remove the OPC belt cartridge and check for
damage. If necessary, replace it.
Entire
sheet is
printed in
black or
color.
The toner cartridge is
defective.
Remove the toner cartridge and check for
damage. If necessary, replace it.
The OPC belt cartridge
is damaged.
Remove the OPC belt cartridge and check for
damage. If necessary, replace it.
Part of
image is
missing.
The media is moist
from humidity.
Remove the moist media and replace it with
new, dry media.
Media with specifica-
tions not covered by
the printer warranty is
being used.
Use media that is covered by the printer war-
ranty.
The toner cartridge is
defective.
Remove the toner cartridge and check for
damage. If necessary, replace it.
The OPC belt cartridge
is damaged.
Remove the OPC belt cartridge and check for
damage. If necessary, replace it.
Image is
too dark.
The toner cartridge is
defective.
Remove the toner cartridge and check for
damage. If necessary, replace it.
The OPC belt cartridge
is damaged.
Remove the OPC belt cartridge and check for
damage. If necessary, replace it.
Symptom Cause Solution