Printer User Manual
Table Of Contents
- magicolor 6110 User’s Guide
- Contents
- Replacing Consumables
- Using Media
- Maintaining the Printer
- Troubleshooting
- Installing Other Accessories
- Introduction
- Antistatic Protection
- BuzzBox
- Cabinet
- Color Calibration Kit
- Dual In-Line Memory Modules (DIMMs)
- Duplex Unit
- Emulations, Fonts, and Other Software
- Lower Feeder Unit (LFU)
- Interfaces and Daughterboards
- SCSI Interface
- Internal IDE Hard Disk Drive
- SC-210 Color Convenience Copier
- Security Key
- Time-of-Day Clock
- Color Printing
- Repacking the Printer
- Technical Specifications
- Requirements
- Engine and Controller Specifications
- Print Media
- Document Option Commands
- Supported DOCs
- Header/Trailer Page Commands
- HP-GL Emulation Commands
- HP PCL 5e Emulation Commands
- Lineprinter Emulation Commands
- PostScript Emulation Command
- CCITT Groups 3 and 4 Commands
- Document Formatting
- Job and Subjob Boundary Commands
- LN03 Plus Commands (Optional Emulation Required)
- CALS Commands (Optional Emulation Required)
- TIFF Commands (Optional Emulation Required)
- Menu Chart Conventions
- Index
Solving Problems with Printing Quality
95
Vertical
streaking
appears.
The laser lens cover
may be dirty.
Check to see if the laser lens cover is dirty. If
necessary, clean it with a clean soft cloth.
The corona wire inside
the OPC belt cartridge
may be dirty.
Clean the corona wire.
One or more toner car-
tridges may be defec-
tive.
The item may be defective or misinstalled.
Remove the item, check it for damage, and
reinstall it. If necessary, replace it.
The OPC belt cartridge
may be defective or
misinstalled.
The fuser unit may be
defective or misin-
stalled.
The transfer unit may
be defective or misin-
stalled.
If a wide vertical white
band appears, check
the transfer drum sur-
face.
Clean the transfer drum surface. If necessary
,
clean the oil off the surface.
Make sure that the transfer unit is closed.
Symptom Cause Solution