Specifications

English-19
English
RED
GREEN
BLUE
Adjusts color gamut. When the selected settings are outside of the LCD gamut, the
indicator on the OSD will turn magenta.
UNIFORMITY This function electronically compensates the slight variations in the white uniformity
level that may occur across the display area of the screen. These variations are a
characteristic of LCD panel technology. This function evens out the luminance uniformity
of the display. Selectable UNIFORMITY levels are OFF, LOW and HIGH.
NOTE: Using the UNIFORMITY feature does reduce the overall peak luminance of the
display. If greater luminance is desired over the uniform performance of the display, then
UNIFORMITY should be turned off. A higher level produces a better uniformity result, but
may also reduce CONTRAST RATIO.
AMB. LIGHT COMP. Adjusts the luminance and gamma value to be in user setting value including outside
luminance level.
OFF: No ambient light compensation.
1: Compensation based on the infl uence of external light measured during the
calibration.
2: Compensation based on the infl uence of surrounding light with constant
measurement of external light.
Tag2 SHARPNESS This is a digital capability for keeping a crisp image at all signal timings. It continuously
adjusts to maintain as distinct or as soft image as you prefer, and is set independently
according to different timings. Press “LEFT” or “RIGHT” to adjust.
RESPONSE
IMPROVE
Turns the Response Improve function on or off. Response Improve may reduce blurring
that occurs in some moving images.
COLOR
STABILIZATION*
1
Stabilizes the color of the image.
OFF: No function.
ON: Stabilize Color.
NOTE: When the function is ON, the lifetime of the LUMINANCE setting level will be
reduced.
(6 - AXIS ADJUST) HUE: Adjusts the hue of each color*
2
. The change in color will appear on screen and the
menu color bars will show the amount of adjustment.
SATURATION: Adjusts the color depth of each color*
2
. Press the “RIGHT” button and the
color vividness increases.
OFFSET: Adjusts the color brightness of each color*
2
. Press “RIGHT” button and the
color Brightness increases.
*2: RED, YELLOW, GREEN, CYAN, BLUE and MAGENTA.
PICTURE MODE SW PICTURE MODE is set ON/OFF. Setting “PICTURE MODE 2” OFF disables change to
“PICTURE MODE 2”.
Tag3 DVI LONG CABLE
(DVI input only)
Compensates for image degradation caused by using a long DVI cable.
There are 4 possible settings, with “0” being the lowest level of compensation and “3”
being the highest level. The default setting is “1”.
DP LONG CABLE
(DisplayPort input
only)
Compensates for disturbed image caused by using a long DisplayPort cable.
There are 2 possible settings, 1 and 2. Setting “2” produces a better result, but may
reduce display colors. The default setting is “1”.
*1 This item will not be reset during a FACTORY PRESET.