User's Guide

- x -
INSTALLING IN RACK
Your server switch unit can be installed in the rack by using the provided rails.
Do not use the server switch unit in any unapproved place.
Install the server switch unit on a standard EIA 19-inch rack assembly. Do not
install the rack containing the server switch unit in a place inappropriate to the
rack installation environment.
Failure to follow these instructions may cause some bad influences to be
imposed on the server switch unit and other systems installed on the rack and
also a fire or personal injury due to falling of the rack may occur. For the
detailed explanation on the place where the server switch unit should be
installed and the earthquake-resistant construction for the rack, refer to the
manual attached to the rack or contact you service representative.
Always install the server switch unit on a rack conforming to the relevant
standard.
Install the server switch unit on a rack confirming to the EIA standard for the
NEC Express server to be used. Do not use the server switch unit with
installed on any other rack than standard EIA 19-inch rack or without the
installation on a proper rack. Failure to follow these instructions may cause the
server switch unit to operate incorrectly and/or personal injury or damages of
surrounding devices to occur. Contact your service representative for the
racks available for the server.
Do not pinch your finger with rails or other components.
Note sufficiently that your fingers may not be caught between a rail and
another mechanical part or cut by a rail at installation or removal of the server
switch unit from the rack.
Do not press the release lever with your finger.
When installing/removing the NEC Express server in/from the rack, the sliding
rails attached to the server may be locked on its way. If the sliding rail has
release levers on its left and right sides, use the screwdriver or equivalent tool
to press the release lever. Pressing the lever with your finger may cause
personal injury.