User's Guide

INSTALLATION
The server switch unit can be placed on a desktop, or installed in a standard EIA 19-inch rack
assembly.
INSTALLATION OF RACK
Refer to the documentation attached to the server rack or contact your service representative for the
rack installation of the server switch unit.
Follow the instructions below to install the rack assembly.
Observe the following instructions to use the server and peripheral devices
safely. Failure to follow these instructions may result in death or serious
personal injury. See pages iii to xvi for details.
Do not use the server switch unit in any unapproved environments.
Observe the following instructions to use the server and peripheral devices
safely. Failure to follow these instructions may cause a fire, personal injury,
or property damage. See pages iii to xvi for details.
Do not carry or install the rack assembly only by a single person.
Do not install the devices where the load may be concentrated on a
specific point.
Do not install any server on the rack only by a single person.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not provide the wiring exceeding the rating power.