User's Guide

INSTALLING SERVER SWITCH UNIT ON RACK
Follow the server switch unit on a proper rack in the following procedure:
Observe the following instructions to use the server and peripheral devices
safely. Failure to follow these instructions may cause a fire, personal injury,
or property damage. See pages iii to xvi for details.
Do not use the server switch unit in any unapproved place.
Avoid contact with the server switch unit including cables during
thunderstorms. Doing so may cause an electric shock.
The server switch unit should be mounted on a rack following the proper procedures listed below;
1. Remove the console connection cable from the rear of the unit.
Remove the four shock absorbers located at the bottom of the unit (if installed).
2. Remove the four flat head screws from the left and/or right ends of the console panel.
(Keep these screws for future use.)
3. Remove the console panel from the unit and install the smaller rack mount bracket onto both
sides of the panel by using screw B (two screws each).
Switch side