User's Guide

Take the following steps to connect cables.
When connecting with 8 Servers
1. Connect the keyboard/mouse and display connectors of the first server through the dedicated
cable (K410-118 or K410-119) to the server switch unit, connecting first the server switch
unit side, then the server side. ((1), (2) in the figure above).
NOTE：It is recommended to attach a label to the cable with connector
name and destination device name filled in. It is useful when installing,
relocating, or cleaning the unit.
2. Connect servers two to eight as necessary. ((1), (2) in the figure above).
NOTE：Connect the interface cable to the server switch unit side first,
then the server side.
3. When all servers are connected to the server switch unit, connect the keyboard, mouse, and
the display units to the KB, MOUSE, and CONSOLE connectors. ((3) in the figure above.)
4. Finally, connect the power cords of the servers and display unit and the AC cord of the server
switch unit into the AC outlet. ((4) in the figure above)
NOTE：Fix the cable of the AC cord with the attached tie wraps to the
rack mount bracket(large) or an appropriate location on the rack to
prevent disconnection.
5. Fix the cables to the rack with the attached tie wraps.
6. After confirming that all the connections are properly in place, power ON the servers
sequentially. Select each of the servers to confirm that it has started normally and is set
correctly.
7. If the keyboard, mouse, and/or display monitor are not set correctly, set and start each device
again.