Operation Guide

- 146 -
Apply
Select the file and click the [Run] button to transfer the update data file to the EM card. The selected
file is updated.
IMPORTANT: If the update is executed from the Web console of the
active EM card, the firmware of the active EM card is updated. It is
recommended to execute the update from the Web console of the
standby EM card.
After updating, the EM card is rebooted automatically.
In the duplexed EM card configuration, the active EM card is switched
by the switchover feature if the update is executed on the active EM
card.
Executing the "apply" command reboots the EM card. While rebooting,
the bridge and SNMP functions are stopped. Accordingly, the
connection via the management LAN of CPU blades and switch
modules is temporarily disconnected. In addition, system monitoring by
NEC ESMPRO Manager is temporarily disabled. If a timeout error
occurs, reconnect after the active EM card has rebooted.
The screen shown below is displayed while the update is in progress:
NOTE: The on-screen information is not updated automatically. To
view the latest information, click the [Reload] button.
When the update process is complete and the EM card is rebooted, this screen is not displayed even
though the [Reload] button is clicked.