Operation Guide

- 71 -
setdsl
Outline
Activates the menu to set linkage with NEC DianaScope.
Syntax
setdsl
Parameter
None
Details
– Changes the user password when using the EM card in linkage with NEC Dianascope.
The password must be 16 characters or less.
– Enables or disables linkage with NEC DianaScope. The default value is "Enabled." The
connection from NEC DianaScope to the EM card is enabled.
The EM cards in slot EM1 and EM2 use the following IP addresses for linkage with NEC
DianaScope:
[Fixed IP] of the EM card installed in slot EM1
[Fixed IP] of the EM card installed in slot EM2
NOTE: See [Initial Setup] [Configuration File] [IP Address of
EM Card] for details.
This command can be executed only on the active EM card.