User Guide

187
Supplementary information
You cannot select the following combination for power control policy and power redundancy mode.
Power control policy: performance preferred mode (PERFORMANCE)
Power redundancy mode: N+N redundant mode (AC)
Configuring a time zone
Overview
Specifies the time zone of the EM firmware.
Command name
SET TIMEZONE
Argument
<Time zone>
Example of execution
Default value
JST
Supplementary information
See "Appendix" for information about available time zones.
This command does not verify the validity of the time zone specified by the argument so that new time
zone definitions could be added later.
When this command is used to configure a time zone, make sure to set an accurate value.
Displaying all information about configuration of the blade enclosure.
Overview
Displays the results of running the following commands in sequence. Information other than the results of
execution of these commands is displayed as well.
SHOW DATE
SHOW VERSION
SHOW RACK NAME
SHOW RACK UID
SHOW ENCLOSURE INFO
SHOW ENCLOSURE STATUS
SHOW SERVER LIST
SHOW SERVER INFO ALL
SHOW SERVER STATUS ALL
SHOW SERVER PORT MAP ALL
SHOW SWITCH LIST
SHOW SWITCH INFO ALL
SHOW SWITCH STATUS ALL
SHOW SWITCH PORT MAP ALL
SHOW ENCLOSURE TEMP
SHOW ENCLOSURE FAN ALL
SHOW ENCLOSURE POWERSUPPLY ALL
SHOW POWER
SHOW NETWORK
SHOW SNMP
SHOW USER LIST
SHOW EM INFO
SHOW EM STATUS
SHOW TOPOLOGY