User Guide

212
WH040001120 console login:
-----------------------------------------------------------------------------
-
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode >
Switch module serial console operation menu
―To modify the serial console connection settings
Press <C> key to enter the serial console settings menu. In this menu, you can modify the settings of:
About this session (the prohibition of use of escape characters on the serial communication)
About the serial communication (a baud rate and a flow control policy)
-----------------------------------------------------------------------------
-
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode > C
Change settings for: L)ocal Session, R)emote Port [Switch Mo], E)xit L
Change Local: D)isable Escape Character, E)xit >
Operation menu related to the session currently being connected
When you select "D)isable Escape Character", the serial connection stop to use of escape characters Note
that this configuration might disable operations which require use of escape characters.
To cancel the prohibition:
To cancel the prohibition, perform the key operation described in the "to start the menu" 12 times.
-----------------------------------------------------------------------------
-
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode > C
Change settings for: L)ocal Session, R)emote Port [Switch Mo], E)xit R
Settings: B)audrate; flow control: N)one H)ardware S)oftware; E)xit > B
Baud: A)1200 B)2400 C)4800 D)9600 F)19200 G)38400 H)57600 I)115200; E)xit >
Serial console connection settings menu
You can change the baud rate and the flow control policy from the serial console connection settings
menu.
Baud rate: 1200bps, 2400bps, 4800bps, 9600bps, 19200bps,
38400bps, 57600bps, 115200bps
Note: Although you can set all baud rate settings from the EM firmware, you should specify the baud rate
which is supported by the connected switch module. When you select an unsupported baud rate,
the serial connection might be disconnected immediately. (Information about a supported baud rate
is available from the User's Guide of the installed switch module.)
Flow control: None, Hardware (CTS/RTS), Software (Xon/Xoff)
Note: Information about the flow control settings will be found in the User's Guide of the installed switch
module.