User Guide

231
NEC DianaScope Manager, Agent
NEC DianaScope is software designed for reducing operational management costs by remotely
managing servers.
The DianaScope is primarily made up of "NEC DianaScope Manager" running on a management PC
(called a "DianaScope server") and "NEC DianaScope Agent" running on a managed server. (The
management PC, the EM console can live together in one PC.) The DianaScope Manager has
information collection and server monitoring functions by communication with the EM card in the
blade enclosure. For information on how to install, configure and operate NEC DianaScope, refer to
the NEC DianaScope Installation Manual and user's guide of CPU blade.
Check that the versions of NEC DianaScope Manager and NEC DianaScope Agent are following
versions or later.
DianaScope Manager (Ver. 1.09.00)
DianaScope Agent
- Windows version (Ver. 2.04.01)
- Linux version (Ver. 2.04.01)
NEC DianaScope Manager and NEC DianaScope Agent can be downloaded from the distribution
site below.
http://www.nec.co.jp/express/
● Setting a user password of DianaScope Gateway
NEC DianaScope Manager requires you to enter an authentication key when a server is registered.
Enter the user password of NEC DianaScope Gateway that you have set by the SET
DSGPASSWORD command on the CLI of an EM card. (For details, refer to "Initial settings"
"Commands" and the installation manual of NEC DianaScope.)
● Setting a status of NEC DianaScope Gateway
The status (enable/disable) of NEC DianaScope Gateway should be set to "enable" to use
monitoring function of NEC DianaScope Manager. (The default setting is "enable.") You can
confirm the status of NEC DianaScope Gateway by using the SHOW DSGSTATE command on
the CLI of the EM card. For details, refer to "Commands".)
● Setting an IP address of an EM card
When using NEC DianaScope, you need to specify multiple of four for the last numeric value of
<IP address of floating IP (Active EM)> (like 192.168.1.4 or 192.168.1.8). (You can confirm the
IP address of an EM card by the SET NETWORK ADDRESSRANGE command on the CLI of an
EM card. For details, refer to "Commands".)