User guide

10
Installation, relocation and storage of the blade enclosure
Separate the blade enclosure into two components and carry each
component with two or more people.
When you want to carry the blade enclosure, separate the rear cage from the module
to make the blade enclosure into two components. With no modules such as a CPU
blade or power unit installed, the enclosure and the rear cage weigh 35.5kg and
31.5kg respectively. Carrying the enclosure or rear cage alone may result in injury.
Carry the enclosure/rear cage with two or more people and firmly hold the handles
of the enclosure or any designated areas. Do not carry the blade enclosure if any
module, such as a CPU blade or power unit, is installed.
Do not install the blade enclosure in a place other than specified.
Do not install the blade enclosure in a place other than specified in this guide. Avoid
the following locations. There is a risk of fire.
● a dusty place
● a humid place located near a boiler, etc.
● a place exposed to direct sunlight
● an unstable place
● a non-restricted access place
Do not use or store the blade enclosure in a corrosive environment.
Avoid using or storing the blade enclosure in an environment which may be exposed
to corrosive gases, such as those including but not limited to: sulfur dioxide,
hydrogen sulfide, nitrogen dioxide, chlorine, ammonia and/or ozone. Avoid
installing the blade enclosure in a dusty environment or a place that may be exposed
to corrosive materials such as sodium chloride and/or sulfur.
Avoid installing the blade enclosure in an environment that may have excessive
metal flakes or conductive particles in the air.
Such environments may cause corrosion or short circuits within the blade enclosure,
resulting in damage to the blade enclosure and possibly a fire hazard.
If there are any concerns regarding the environment at the planned site of installation
or storage, please contact your sales representative.
Do not use the blade enclosure with its covers and fan units removed.
Do not use the blade enclosure with its covers and fans removed. If you use the
blade enclosure without them, the cooling efficiency inside the blade enclosure
degrades, causing malfunction. Also, dust may get in and cause a fire or electric
shock.
Be careful not to hurt your fingers.
Take precautions to avoid pinching your fingers when installing or removing the
blade server on or from the rack.
Be careful not to drop the blade enclosure.
Firmly hold the handles on both sides of the blade enclosure to install or remove it
on the rack. Since brackets on the rack have no mechanism to prevent the device
from falling off, such as a stopper or lock, pulling a device fully out of the rack can
result in the device falling and causing injury. When you install or remove the blade
enclosure, hold the handles on both sides firmly or use a lifter.
WARNING