User guide

111
Follow the steps below to restore configuration information. To restore configuration information,
you need the backup of the configuration information.
Check
By restoring configuration information, values in each setting are overwritten. For
setting information to be backed up/restored, see "SET FACTORY" in
"Commands." Before restoring configuration information, confirm that the settings
information of each module, including network settings, can be overwritten.
1. Confirm that you have logged in to the EM card as Administrator or a user whose access right
is ADMINISTRATOR or OPERATOR from the CLI of the EM serial console or EM console.
If you have not, log in as "Administrator" or a user whose access right is ADMINISTRATOR
or OPERATOR.
2. Run the following command on the CLI to restore configuration information. For details, refer
to "Commands."
After configuration information is restored, the EM card is automatically restarted.
― Restoring configuration information
Restore configuration information of the blade enclosure by the following command.
Specify a URL on which configuration information has been backed up with the full path
for <URL>.
* "path" contains the name of the file to be backed up.
DOWNLOAD CONFIG <URL>
Important
 If two EM cards are installed, when restoring configuration information on the active EM
card, the same configuration is applied to the standby EM card. It may take several seconds
for applying the configuration to the standby EM card. For more information on the active
EM card etc., refer to "EM card" on page 123.
 Do not install/remove a module or power on/off a module while restarting the EM card.
Doing so might result in not only failure to complete the configuration update but
malfunctions of the module. Do not switch on/off the ID LED of an installed module. The
ID LED may not be appropriately turned on/off.
3. After the EM card is restarted, log in to the CLI of the EM serial console or EM console.
4. Run the following command on the CLI to confirm that the restoration of configuration
information is effective. For details, refer to "Commands."
― Confirming configuration information (highly recommended)
Confirm the configuration information of the blade enclosure by the following command:
SHOW CONFIG
The configuration information is now restored. The password of each user is not backed up.
After restoring configuration information, reconfigure the password of each user. The time zone
is also not backed up. After configuration information is restored, reconfigure it as necessary.
For information on each configuration, refer to "Initial settings."