User guide

113
2. Confirm that you have logged in to the EM card on the CLI of the EM serial console or EM
console.
3. Run the following command on the CLI to connect to a switch module and configure settings.
For details on the procedure after connection is achieved, refer to "Commands" and the User's
Guide of the switch module.
― Connecting a console to a switch module
CONNECT SWITCH <Slot number>
Hint
Generally, a pass-through card does not need to connect to consoles. Depending on
the type of the pass-through card, the specification may differ from the one described
in this document. In this case, use the specification of the User's Guide instead.
Other settings (switch module/through card)
Refer to the User's Guide of the switch module/pass-through card.