User guide

115
Power unit
1. Confirm that the EM card is on.
2. Confirm that you have logged in to the EM card on the CLI of the EM serial console or EM
console.
3. Run the following command on the CLI. For details, refer to "Commands."
― Checking the status of power units
The following command shows the status of a power unit of the blade enclosure on which
the EM card is installed:
SHOW ENCLOSURE POWERSUPPLY <Power unit number | ALL>
If "Failed" is displayed, confirm that the power unit is installed in an appropriate slot. If
it is installed correctly, replace it with another power unit.