User guide

137
Each EM card has a different password for "Administrator" by default.
The initial password is displayed only on EM serial console of EM firmware when an EM firmware
is started by "password recovery."
For information on password recovery, refer to "Password recovery" on page 120.
CLI additional user
You can add or delete a user by using the CLI command.
You can give an added user ADMINISTRATOR, OPERATOR or USER as access right according to the
access range of the user.
There is an upper limit for the number of users that can be added.
30 users at maximum (Default user "Administrator" is included in 30 users.)
User name
Specify a user name with alphanumeric characters and symbols (to be specific, a-zA-Z, 0-9, space, '-'
(en dash), '_' (underscore)) in any combination.
The first character should be always alphabet (a-zA-Z). You can specify alphanumeric characters for the
rest of characters.
Use 1 to 13 characters to specify user name.
Concurrent connection
The number of sessions that can be connected at the same time is limited for CLI.
The maximum number of the sessions is 17 (1+16).
1 session : Operation from the EM serial console
16 sessions : Number of CPU blades