User guide

139
Command
Access
rights
Description
Default value
EM card
active/
standby
Back
up
target
Remarks
SHOW
TOPOLOGY
A/O/U
When multiple blade
enclosures are installed
on the same rack,
displays the connection
status of the blade
enclosures.
N/A
A/S
N
User management command
ADD USER
A
Adds a user to the
system.
Up to 30 users can be
registered.
The user defined by the
system (Administrator)
cannot be added.
Administrator
A
Y
30 users at
maximum
("Administrator"
is included in
30 users.)
ASSIGN [SERVER
| SWITCH]
A
Assigns access
permission to CPU
blades and switch
modules to the specified
user.
N/A
A
Y
ASSIGN EM
A
Assigns access
permission to EM cards
to the specified user.
N/A
A
Y
DISABLE USER
A
Disables a specified user.
The registered
user is set to
"ENABLE" by
default.
A
Y
ENABLE USER
A
Enables a specified user.
The registered
user is set to
"ENABLE" by
default.
A
N
REMOVE USER
A
Deletes a specified user.
N/A
A
N
SET PASSWORD
A/O/U
Sets the password of the
user who executed the
command. The password
must be 3 to 8
characters.
N/A
A
N
SET USER
CONTACT
A
Configures the contact
information of the
specified user. The
contact information must
be up to 32 characters.
""
(not configured)
A
Y
SET USER
FULLNAME
A/O
Configures the full name
of the specified user. The
full name must be up to
32 characters.
"Administrator":
Full name:
System
Administrator
A
Y
SET USER
PASSWORD
A
Sets the password of the
specified user. The
password must be 3 to 8
characters. Only users
with the
ADMINISTRATOR rights
can use this command.
N/A
A
N
SET USER
ACCESS
A
Configures the access
rights for the specified
user.
Access rights:
"ADMINISTRATOR",
"OPERATOR" or "USER"
Only users with the
ADMINISTRATOR rights
can use this command.
Administrator:
"Admin"
A
Y
SHOW USER
A/O/U
Displays a list of users
that are registered with
the EM firmware.
N/A
A/S
N
UNASSIGN
[SERVER |
SWITCH]
A
Removes the access
permission to CPU blade
and switch modules from
the specified user.
N/A
A
N
UNASSIGN EM
A
Removes the access
permission to EM cards
N/A
A
N