User guide

140
Command
Access
rights
Description
Default value
EM card
active/
standby
Back
up
target
Remarks
from the specified user.
System management command
CLEAR SWITCH
SESSION
A/O
Terminates a serial
console session on a
switch module.
N/A
A
N
PING
A/O/U
Sends PING (ICMP Echo
command) for a specified
IP address or server
name.
N/A
A/S
N
SET FACTORY
A
Restores settings of the
EM firmware to their
factory defaults.
Only users with the
ADMINISTRATOR rights
can use this command.
N/A
A/S
N
Enclosure network management command
ADD NETWORK
DNS
A/O
Configures DNS servers.
Up to two DNS servers
can be registered.
N/A
A
Y
ADD TRUSTED
HOST
A/O
Specifies IP addresses
allowing access to the
EM firmware. Up to five
addresses can be
registered.
N/A
A
Y
ADD SNMP
TRAPRECEIVER
A/O
Specifies SNMP trap
destinations. Up to three
destinations can be
registered.
N/A
A
Y
DISABLE HTTPS
A/O
Disables the Web
console function of the
EM firmware.
Enable
A
Y
Do not use.
(only for
maintenance)
DISABLE
TRUSTED HOST
A/O
Disables the IP-based
access control function to
the EM firmware.
Disable
A
Y
DISABLE NTP
A/O
Disables the NTP
function of the EM
firmware.
Disable
A
Y
DISABLE
SECURESH
A/O
Disables the SSH access
to the EM firmware.
Enable
A
Y
DISABLE SNMP
A/O
Disables the SNMP
functions of the EM
firmware.
Enable
A
Y
DISABLE SNMP
TRAPACK
A/O
Disables the SNMP
TrapAck function of the
EM firmware.
Disable
A
Y
DISABLE TELNET
A/O
Disables the telnet
access to the EM
firmware.
Enable
A
Y
ENABLE HTTPS
A/O
Enables the Web console
function of the EM
firmware.
Enable
A
Y
Not used (only
for
maintenance)
ENABLE
TRUSTED HOST
A/O
Enables the IP-based
access control function to
the EM firmware.
Disable
A
Y
ENABLE NTP
A/O
Enables the NTP function
of the EM firmware.
Disable
A
Y
ENABLE
SECURESH
A/O
Enables the SSH access
to the EM firmware.
Enable
A
Y
ENABLE SNMP
A/O
Enables the SNMP
functions of the EM
firmware.
Enable
A
Y
ENABLE SNMP
TRAPACK
A/O
Enables the SNMP
TrapAck function of the
EM firmware.
Disable
A
Y
ENABLE TELNET
A/O
Enables the telnet access
to the EM firmware.
Enable
A
Y
REMOVE
NETWORK DNS
A/O
Removes the IP address
of a DNS server from the
list.
N/A
A
N
REMOVE
TRUSTED HOST
A/O
Removes an IP address
that is configured by the
N/A
A
N