User guide

154
User management commands
Adding a user
Overview
Adds a user who controls and manages the system.
Up to 30* users can be registered.
*"Administrator" is included in 30 users.
Command name
ADD USER
First argument
<User name>
Specify a user name within 13 characters.
Note:
Alphanumeric characters and some symbols (a-zA-Z, 0-9, blank, '-' (hyphen), '_' (underscore)) can
be used for the user name.
Make sure to use an alphabet (a-zA-Z) for the first character. For the following characters, use
alphanumeric characters.
The length of <User name> should be from 1 to 13 characters.
No reserved words can be specified for <User name>.
Reserved word means "ADMINISTRATOR", "OPERATOR", "USER", etc.
Second argument
<Password> (optional)
Specify a password by using 3 to 8 alphanumeric characters. The first character of the password must be an
alphabet.
When you choose not to configure a password for the user, a message prompting you to enter a password
appears. The message waits for entry of a password.
Note:
No reserved words can be specified for <Password>.
Reserved word means terms defined in the command line such as "SET", "ADD", and "RACK."
Example of execution
1Z34AB7890(Administrator)> add user test
New Password: ****
Confirm : ****
User "test" created.
1Z34AB7890(Administrator)>
Example of execution of the command to add a user
Default value
Supplementary information
Only users with the ADMINISTRATOR right can use this command.
Assigning a user (for CPU blades/switch modules)
Overview
Configures access permission to the CPU blades and switch modules for the specified user.