User guide

164
Item
Default value
Remarks
Default gateway
"0.0.0.0"
DNS1
"0.0.0.0"
DNS2
"0.0.0.0"
NTP1 (Primary)
"0.0.0.0"
NTP2 (Secondary)
"0.0.0.0"
NTP polling interval (sec)
720
Value range:
0 (disabled), from
60 to 9999
Connectible IP address (up
to 5 addresses)
"0.0.0.0"
Default user settings
"Administrator"
User settings are
included. The
password default
value of
Administrator
differs from one EM
card to another. It is
found on the EM
card label or tag
label on the release
lever.
SNMP settings
Community name for Get
"public"
Community name for Get/Set
"public"
Community name for Trap
"public"
Location
"unknown"
Contact destination
"unknown"
Trap destination
""
Unconfigured
TrapAck settings
Disable
TrapAck port number
"5002"
DianaScope Gateway
settings
DSG user password
"guest"
DSG status
"1"
1:Enable
CPU Blade setting
CPU Blade 遅延時間
(スロット個別設定)
"0"
0 (disabled)
Enclosure management command
Power control policy
PERFORMANCE
Power redundancy mode
POWERSUPPLY
(N+1 redundant mode)
Power saving mode
OFF (disable)
maximum consumable power
setting
OFF (disable)
Supplementary information
Only users with the ADMINISTRATOR right can use this command.
Type YES as prompted by a message on the screen.