User guide

165
Enclosure network commands
Registering DNS servers
Overview
Configures DNS.
Up to two DNS servers can be registered.
Command name
ADD NETWORK DNS
Argument
<IP address>
Example of execution
Default value
Supplementary information
Changes you make for the DNS settings will take effect after the EM card is restarted.
Registering addresses to allow IP access
Overview
Specifies IP addresses allowing access to the EM firmware.
Up to five addresses can be registered.
Command name
ADD TRUSTED HOST
Argument
<IP address>
Example of execution
Default value
Supplementary information
Registering SNMP trap destinations
Overview
Specifies SNMP trap destinations.
Up to three destinations can be registered.
Command name
ADD SNMP TRAPRECEIVER
First Argument
<IP address>
Second Argument
<Community name > (optional)
Use up to 32 characters to specify a community name.
When you skip the community name, the default community name is registered.