User guide

171
Command name
REMOVE SNMP TRAPRECEIVER
Argument
<IP address>
Example of execution
Default value
None (not configured)
Supplementary information
Configuring IP addresses
Overview
Configures IP addresses of EM cards, CPU blades, and switch modules.
The address of CPU blade and switch module means the Slot1 1 address. From the Slot2 on, subsequent
addresses are configured.
Command name
SET NETWORK ADDRESSRANGE
First argument
<EM card IP address>
Second argument
<CPU blade/switch module start up IP address>
Third argument
<Subnet mask>
Example of execution
1Z34AB7890(Administrator)> set network addressrange 192.168.1.150 192.168.1.200
255.255.255.0
Setting IP address 192.168.1.150 & netmask 255.255.255.0 for Enclosure Manager.
Setting IP address 192.168.1.200 for CPU Blade and Switch Module.
Setting netmask 255.255.255.0 for CPU Blade and Switch Module.
Network Address settings successfully updated.
These setting changes will take effect immediately.
1Z34AB7890(Administrator)>
Example of execution of the command to set the IP address
Default value
Start up IP address
EM card : "192.168.1.8"
CPU blade/switch module : "192.168.1.12"
Subnet mask
"255.255.255.0"
Supplementary information
The following values can't be specified for <CPU blade/switch module start up IP address>.
*.*.*.0, *.*.*.255 ("*": the wildcard character)
For details on how to set, refer to "Network settings (EM card)".