User guide

200
Default value
Supplementary information
Only users with the ADMINISTRATOR right can use this command.
Configuring the power saving mode
Overview
Configures the power saving mode of the power control function.
Power saving function ON: Turns off power unit(s) automatically, when surplus power unit(s) exist.
Command name
・SET POWER SAVINGS
Argumen
“ON” | “OFF”
ON： Enables power saving function
OFF： Disables power saving function
Example of execution
1Z34AB7890(Administrator)> set power savings on
Power Settings were updated to:
Redundancy Configuration : Power Supply Redundant
Power Policy Configuration : REDUNDANCY
Dynamic Power Savings : On
Limit DC Output : Not Set
Capacity : 11250 W
Redundant Capacity : 2250 W
Redundant Power : 9000 W
Power Allocated : 1289 W
Consumed Power : 219 VA
Maximum Consumable Power : 10944 VA
1Z34AB7890(Administrator)>
Example of execution of the command to configure the power saving mode
Default value
"OFF" （disable）
Supplementary information
When the configuration is successfully modified, it is effective.
Configuring the maximum consumable power setting
Overview
Configures the maximum power consumption for each enclosure.
The maximum power consumption management is to manage the power consumption of each of the
modules configuring the system so that the maximum power consumption in the system is maintained
within a certain value. If you enable this function, the EM card uses the value smallest among <The
maximum power consumption> and upper limits determined by the power redundancy mode and the power