User guide

219
Operation status
Thermal status
CPU status on switch modules
STATUS LED status
ID LED status
Power-supply status
Power consumption in operating state (Maximum)
Power consumption in standby state
E-FUSE status
Command name
SHOW SWITCH STATUS
Argument
<Slot number> | <Slot number> - <Slot number> | <Slot number> , <Slot number> | "ALL"
<Slot number> and '-'(hyphen) or ','(comma) must be separated by a blank space.
Example of execution
1 Z34AB7890(Administrator)> show switch status 3
Switch Module #3 Information:
Status : OK
Thermal : OK
CPU Fault : OK
Health LED : OK
ID LED : Off
Powered : On
Power On Watts : 48
Power Off Watts : 5
E-FUSE Status : OK
Diagnostic Status:
Internal Data Not Performed
Management Processor OK
Thermal Warning OK
Thermal Danger OK
I/O Configuration OK
Power Not Performed
Device Failure OK
Device Degraded OK
1Z34AB7890(Administrator)>
Example of execution of the command to display status of switch modules
Default value
Supplementary information
Diagnostic Status indications
Internal Data Shows FRU information validity. OK: valid, Failed: invalid (checksum
error, etc.)
Management Processor Shows the status of management processor on the switch module. OK:
normal, Failed: failure
Thermal Warning Shows the temperature warning status. OK: normal temperature, Failed:
warning temperature, Not Performed: not checked
Thermal Danger Shows abnormal temperature status. OK: normal temperature, Failed:
abnormal temperature, Not Performed: not checked
I/O Configuration Shows E-Keying status. OK: E-Keying succeeded, Failed: E-Keying
failed