User guide

226
Default value
Supplementary information
Configuring the DSG status
Overview
Configures the DianaScope Gateway（DSG） status.
Command name
SET DSGSTATE
Argument
"1" (Enable), "0" (Disable)
Example of execution
1Z34AB7890(Administrator)> set dsgstate 0
Changed DSG State.
1Z34AB7890(Administrator)>
Example of the DSG status configuration
Default value
"1" (Enable)
Supplementary information
When you do not want to disable the system monitoring by the DSG, you should run "SET DSGSTATE
0". This setting disables the system monitoring. In this setting, the EM firmware does not make any
responses to queries from the DSG.
When you want to enable the system monitoring by the DSG, you should run "SET DSGSTATE 1". This
setting enables the system monitoring. In this setting, the EM firmware will make responses to queries
from the DSG.
Displaying the DSG status
Overview
Displays the DianaScope Gateway（DSG） status.
Command name
SHOW DSGSTATE
Argument
Example of execution
1Z34AB7890(Administrator)> show dsgstate
DSG Status:0
1Z34AB7890(Administrator)>
Example of the DSG status display
The output of this command indicates:
1: Enable
0: Disable