User guide

24
Installation
Checking components
See the attached list to check that you have all the accessories and components.
Installing the blade enclosure on a rack
Install the blade enclosure on a rack. This section also describes how to remove the blade enclosure
as well.
Make sure to follow the instructions and notes to use the blade enclosure and other
devices safely. There is a risk of death or serious injury. For more information, see
the descriptions on page 3.
●Do not install the blade enclosure on a nonstandard rack.
●Do not use the blade enclosure in a place other than specified.
Make sure to follow the instructions and notes to use the blade enclosure and other
devices safely. There are risks of a burn, injury, or damage to physical assets. For
more information, see the descriptions on page 3.
●Separate the blade enclosure into two components and carry each component with
two or more people.
●Do not install the blade enclosure in a place other than specified
●Do not use the blade enclosure with its covers and fan units removed.
●Be careful not to hurt your fingers.
●Do not impose loads on the blade enclosure while it is pulled out of the rack.
●Do not cover air vents.
Check components to install
You need the following components:
- Rail bracket (L) (1) (Shipped with the blade enclosure)
- Rail bracket (R) (1) (Shipped with the blade enclosure)
- Core nut (square hole) or clip nut (circular hole) (4) (Shipped with the blade enclosure)
Check
The shapes of rail brackets (L) and (R) are not the same. See the illustrations on the
following pages to check the locations and directions they should be installed. The
rail brackets (L) and (R) can be distinguished from each other by their marks.
CAUTION
WARNING