User guide

28
(1)
(2)
● Install the blade enclosure on the rack.
Hold the blade enclosure with its front facing front with 2 or more people. Slowly put the
L-shaped frames on both the right and left side of the blade enclosure on the L-shaped frames
of the rail brackets that have been attached to the rack.
Important
● When you carry the enclosure, hold the four handles at both sides of the enclosure (two each
on the right and left side).
● When you install the enclosure, stow the four handles at both sides of the enclosure (two
each on the right and left side) to prevent them from bumping against the rack frames.
Check
Check that the enclosure is correctly mounted on the L-shaped frames of the rail
brackets during the installation.
Push the enclosure into the rack until it stops. Use a torx driver (T25) to tighten the front
screws of the blade enclosure (four screws, two each on the right and left) and secure the blade
enclosure to the rack.
● Install the rear cage.
Check
Before installing the rear cage, bend the hinges to the outward direction to prevent
the screws at the rear of the blade enclosure (four screws, two each on the right and
left side) from hitting the rear cage.
1. Firmly hold the handles at both
sides of the rear cage (one each on
the right and left side) and slowly
put the rear cage on the rails of the
enclosure. This step should be
done by two or more people.
Check
Check that the rear cage
is correctly mounted on
the rails of the enclosure
during the installation.
2. Push the rear cage into the
enclosure with two or more people
until it stops.
3. Bend the hinges to the inward
direction. Then, use a torx driver
(T25) to tighten the rear screws of
the blade enclosure (four screws,
two each on right and left side) and
secure the rear cage to the
enclosure.