User guide

39
3. Place the switch module/pass-through
card carefully on a clean, flat table
and open (release) the ejector. When
you open the ejector, press the stopper
locking the ejector rightward.
The illustration depicts a device with a
stopper. If there is no stopper, the
action indicated by (1) is not
necessary.
4. Hold both sides of the switch
module/pass-through card with its ejector
side facing the top and slowly insert the
switch module/pass-through card halfway
into the blade enclosure (about 20 cm).
Important
Do not hold the ejector. Otherwise, the
ejector and the switch
module/pass-through card may be
damaged.
5. Press the frame of the module front with your thumbs with the ejector fully opened slowly into
the blade enclosure.
Hint
Push the front side of the switch module/pass-through card carefully until it is
inserted into the blade enclosure and the ejector closes slightly.
6. Close the ejector slowly.
The midplane connector of the switch module/pass-through card is connected to the midplane of
the blade enclosure.
If you cannot close the ejector successfully, check the stopper.
If you close the ejector while it is not correctly locked, the ejector or the blade enclosure may
be damaged.
(1)
(2)
(1)
(2)