User guide

3. If the CPU blade has any covers on the connectors on the

side that is inserted into the blade enclosure, remove them.

4. Open the CPU blade ejector. If the ejector is secured by a

screw, loosen it.

5. Hold the CPU blade with its midplane connector facing the

blade enclosure and the ejector facing down.

6. Put the end of CPU blade board on the guide rails located at

the upper and lower sides of the blade enclosure and slowly

push the CPU blade into the blade enclosure.

Check

When you insert the CPU blade into the

blade enclosure, make sure the pins on the

blade enclosure frame and the ejector of the

CPU blade fit correctly.

Hint

 If the pins on the blade enclosure frame and the ejector of the CPU blade do not fit

correctly, move the CPU blade right and left to adjust the position.

 When you install a half-height blade, a separator should be installed. When you

install a full-height blade, remove the separator if it is installed.

7. Press the ejector firmly to lock it. Tighten the screws to secure the CPU blade.

8. Write down the information of the installed CPU blade on the blade management sheet that

comes with the blade enclosure.

If a sticker is attached, write down the information on the sticker and affix it to the management

sheet. Keep the management sheet in a safe place.

The ejector facing

down