User guide

Assembling a full-height CPU blade slot cover

When a full-height CPU blade is installed on a blade slot block, one full-height CPU blade slot

cover should be installed on the blank slot in the same block. By combining two half-height CPU

blade slot covers, a full-height CPU blade slot cover can be assembled. See the following

instructions to assemble a full-height CPU blade slot cover.

Important

 Keep all screws.

 To avoid screws and parts falling into the cabinet, device, or module,

do not assemble a full-height CPU blade slot cover near any cabinet,

device, or module.

Use one of the two CPU blade slot covers for the upper level and the other for the lower level.

Start with the CPU blade slot cover for the upper level.

1. Remove 4 screws from the right side

and 2 screws from the left side.

2. Separate the slot cover into two

components (hereafter referred to as

Part A and Part B).

The CPU blade slot cover for the upper level is now ready to be combined.

Right side

Left side

Part A

Part B