User's Guide

21
1 CPU blade slot
Install the CPU blades into these slots. The last digit indicates the installation order.
2 Optical disk drive
Hold this handle when installing or removing the Blade Enclosure.
2-1 Access lamp
2-2 Eject button
2-3 Emergency hall
3 USB connector
This connects a USB device. The USB device is connected to the CPU blade in the slot specified by
SIGMABLADE monitor.
4 SIGMABLADE monitor
4-1 LCD
This displays the system status and CPU blade status installed in the Blade Enclosure.
4-2 Power lamp
This indicates power status of Blade Enclosure and SIGMABLADE monitor.
The lamp goes on green when the Blade Enclosure is powered. It goes off when the Blade
Enclosure is powered off.
4-3 Status lamp
This indicates the statuses of Blade Enclosure and SIGMABLADE monitor.
The lamp goes on green when the Blade Enclosure is powered. It goes off when the Blade
Enclosure is powered off.
4-4 ID lamp
This identifies the CPU blade in the system.
The light goes on blue when you press the ID button (4-5).
When the remote console sends the turn-on command and the command is received, the lamp
blinks blue. If you press the ID button while this lamp lights or it is flashing, the lamp goes off.
4-5 ID button
Press this button to turn on or off the ID lamp.
4-6 Reset button
Press this button to restart optical disk drive and USB devices connected to the USB.
4-7 Menu button
Press this button to restart optical disk drive and USB devices connected tot the USB.
4-8 Enter button
Use this button to select a menu or determine the selection.
4-9 [][][][] button
Use these buttons to move cursor, or change value on the cursor position.