User's Guide

30
Installation
Checking components
See the packing list to ensure that you have everything and that individual components are not damaged.
Installing the Blade Enclosure to the rack
This subsection describes illustrated instructions for the installation and removal of Blade Enclosure to a
rack assembly.
The blade Enclosure can be installed on the proper rack provided by NEC or several third-party vendors.
(Each third-party vendor’s rack must conform to the EIA standard. In addition, the rack should be
appropriate to the Blade Enclosure. Contact your sales representative for details.)
Observe the following instructions to use the Blade Enclosure safely. Failure to
follow these instructions may result in death or serious personal injury. See pages
4 to 14 for details.
 Do not use an nonstandard rack
 Do not use where undesignated
Observe the following instructions to use the Blade Enclosure safely. Failure to
follow these instructions may result in death or serious personal injury. See pages
4 to 14 for details.
 Use four or more people to lift the enclosure
 Make sure to remove all the CPU Blades and power units before removing the
enclosure
 Do not install in a place other than specified
 Do not use with any cover and/or the fan unit taken out
 Be careful not to catch your fingers on any part of the enclosure
 Do not place any load on an halfway-pulled-out enclosure
 Do not block any ventilation openings
CHECK:
Before mounting a blade enclosure in a rack, remove the front and the rear doors from the rack as
necessary.
(For more information, refer to the respective rack instructions.)