User's Guide

31
Checking the parts for mounting
Prepare the following parts (all included with the Blade Enclosure):
 One rail bracket (L)
 One rail bracket (R)
 Twelve screws (M5 type)
 Eight washers (M5 type)
 Four core nuts
CHECK:
The left (L) and the right (R) rail brackets have different shapes. See the illustration on the next page to
determine where in the rack and in which orientation the brackets are to be attached.
Necessary equipment
A Phillips screwdriver (No.2) is needed to mount an enclosure in a rack.
Attaching the core nut
First, determine where the Blade Enclosure, rail brackets and core nuts are to be attached. To see where to
attach the core nuts, see the illustrations starting on the next page.
There are marks next to the holes in the rack frames, placed at 1U intervals (1U represents one rack unit of
height). Because the Blade Enclosure is 10U (approximately 445mm) in height, it is installed at the 10U
space in the rack frame.
CHECK:
Ensure that the left and the right core nuts installed in the rack frames are at the same height.