User's Guide

33
Installation procedure
Use the following procedure to rack-mount the Blade Enclosure.
Attaching rail brackets
Adjust the length of both the left and right rail brackets by sliding them to fit the depth of the rack so that
both ends of the rail project through the appropriate square holes in the front and the rear of the rack frames.
Once the brackets are aligned, use four M5 screws with a washer on each (both included with the Blade
Enclosure; refer to the previous page), to secure a rail bracket on the front and rear frames of the rack.
Do the same for the other side of the rack, using a total of eight screws for the both rail brackets.