User's Guide

43
Removing power units
Use the following procedure to remove a power unit.
1. Locate the power unit to be removed.
2. If using a non-redundant configuration, refer to the table on page 24 and shut down the CPU blade in
the affected slot and power off the CPU blade.
3. Detatch the tie lap (black band) and remove the AC Cable.
.
4. Lift the power unit’s ejector up to unlock it.
Then hold the handle and pull it out slowly
about 10cm.
5. Hold the top and bottom of the power unit firmly,
and remove it from the Blade Enclosure.
CHECK:
If you want to use the blade enclosure without
using a new power unit installed in the slot,
attach a slot cover in the slot.
The procedure is now complete.
Tie lap