User's Guide

54
IMPORTANT:
 The N code of the compatible CPU blade slot cover is N8405-046.
 If you install a full-height CPU blade, you must remove the separator between the slot of install
position.
 If you install a half-height CPU blade, separator must be installed between the slot of install
position. The separators are installed when the enclosure is shipped.
 If you install only one full-height CPU blade into full-height, double-width partitions (slots 1/2/9/10,
slots 3/4/11/12, slots 5/6/13/14, and slots 7/8/15/16), prepare one pair of two CPU blade slot covers
and install it into a vacant slot. Refer to the figure on the next page for the partitions. For how to
combine two CPU blade slot covers to make a full-height CPU blade slot cover, refer to
“Assembling and disassembling a full-height CPU blade slot cover”.
 Mixed installation of a half-height and a full-height CPU blades are unavailable. Same slots refer to
the full-height slots 1/2/9/10, slots 3/4/11/12, slots 5/6/13/14, and slots 7/8/15/16. Refer to the figure
on the next page.
 If you install one or more 4G FC switch (12 ports)(N8406-019) into a Blade Enclosure, install them
on the upper stage of the enclosure in the order of slot 1 to 8 consecutively. Then follow the
instruction on the previous page to install the CPU blades that has no connection to 4G FC switches
(12 ports). Note that 4G FC switches (12 ports) can only be connected the upper stage of the Blade
Enclosure unit.