User's Guide

3. Remove the connector covers (if installed), located on

the side that connects to the Blade Enclosure, from the

CPU blade.

4. Open the CPU blade’s ejector.

If the ejector is secured with screws, loosen

them to unlock the ejector.

5. Hold the CPU blade so that its mid plane connector

is facing the Blade Enclosure and the ejector is

facing down.

6. Align the board edges of the CPU blade with the

guide rails at the top and bottom of

the Blade Enclosure, and insert it slowly and

carefully into the enclosure.

CHECK:

When inserting the CPU blade into the Blade

Enclosure, make sure that its ejector engages

with the pin on the enclosure frame.

TIPS:

 If the CPU blade’s ejector does not

engage with the pin on the Enclosure

frame, shift the CPU blade slightly

toward the horizontal direction to align

them.

 If installing a half-height CPU blade in a

slot that has no separator in it, install a

separator before installing the CPU

blade. If installing a full-height CPU

blade in a slot that has a separator in it,

remove the separator before installing

the CPU blade.

For more details on installing and

removing separators, see “Installing

separators” on page 63.

7. Push the ejector until it is locked and then tighten

the screw to secure the CPU blade.

8. Fill in the information about the installed CPU blade

on the blade management sheet attached to the Blade

Enclosure.

If a sticker is enclosed, fill in the information on

the sticker, attach it to the management sheet, and

keep the sheet in a safe place.

The procedure is now complete.

Ejector