User's Guide

76
When the disk eject fails
When the optical drive fails to eject the tray with the eject button, follow the procedure below.
1. Shutdown the OS, and press the power switch to
power off the unit. The power lamp goes off.
2. Insert a metal pin of approximately 1.2mm in diameter
and 100mm in length into the emergency hole on the right
front of the optical disk drive. You can use a straightened
large paper clip as a substitute.
Then gently push it in until the tray is ejected.
IMPORTANT:
 Do not use a toothpick or plastic stick that is easy to break.
 If you are still unable to remove the disk after performing the above procedure, contact your service
representative.
3. Hold the tray and pull it out.
4. Remove the disc.
5. Push the tray back into its original position.